When it comes to using something to help with keeping cross cuts and rips straight, what do you prefer to use and why?
Bora
Rockler
Peach Tree
Or a homemade plywood/straightedge jig
This is assuming you would be using a circular saw or jig saw and do not own a table saw.
Tags:
thanks, Rich! I'll have to look into those.
Rich, is that the one by Griset?
I have used the Kreg rip cut many times successfully. I also made my own straight edge jig of a 4ft length. I placed wall board and slat board on my garage walls a couple of years ago and cutting down 4x8 sheets was a challenge for me made easier using those two methods.
I just routed in tracks to my work bench in progress yesterday with the Rockler Low profile straight edge system. It was easy to use and the T-Square feature kept me in check.
Rick,
I purchased two different higher priced circular hand saws---
neither one had the blade aligned with the base.
One saw had a variation of .04 to .06", from the front of the blade to the back of the blade, and the other was .03 to .04", in a span of just 7". (The blade was not parallel to the base).
It's acceptable for cutting 2X lumber free-hand; however,
unacceptable for making accurate cuts with a straight edge guide.
I took one saw to the OEM's authorized servicer---they couldn't do anything with it.
Changing out the base plate, still produced the same results.
Both brand saws are currently made in China.
Returned both of them to the dealer.
Went back to using my older reliable saw, which makes accurate straight cuts, 8 ft long and within .02-.03,
using a straight-edge guide.
Jay Bates has a slick setup with dust collection.
http://jayscustomcreations.com/category/woodworking-2/my-shop/
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
© 2024 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service