Kreg Owners' Community

Keith Woythaler
  • Rockville Centre, NY
  • United States
Share on Facebook
Share

Keith Woythaler's Discussions

Edge banding question
7 Replies

I plan on doing solid oak edge banding around the table top of a media console as well as on the adjustable shelves of the console. If I attach the solid banding with pocket screws, can I then route…Continue

Started this discussion. Last reply by Elizabeth Leveques Dec 30, 2015.

Screw selection question
5 Replies

My next build is an entertainment center consisting of both oak veneer plywood and actual oak dimensional lumber (mostly for face frame and hardwood edge banding --- not the iron on banding), both…Continue

Started this discussion. Last reply by Elizabeth Leveques Dec 30, 2015.

Advice on a stand for the Hitachi 12" sliding miter saw?
12 Replies

Hi there everyone,I am hoping to purchase a Hitachi C12RSH 12" sliding compound miter saw.  Most of my work gets done outside, as the garage I currently work out of has no electricity.  I know this…Continue

Started this discussion. Last reply by Wendy Ratcliff Dec 30, 2014.

Staining Pine Question; need some assistance
10 Replies

Hi Everyone,I am finishing up the construction of a bookcase/shelving unit (roughly hip height but wide), which is made of mostly (98%) pine (except for some pieces that were ripped from 2x4s [not…Continue

Started this discussion. Last reply by thomas b farrell May 19, 2014.

 

Keith Woythaler's Page

Profile Information

Which Kreg products do you own?
Kreg Jig® R3 (Jr.)

Comment Wall

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

  • No comments yet!
 
 
 

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

First time I really had a need for the ACS miter guide.

I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue

Tags: ACS

Started by Adam in General Woodworking May 6.

What thread and size screw to use 2 Replies

I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue

Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2022   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_