Tags:
I've been watching this post since 01/08/2011 for my own knowledge.
Apparently there is no answer, or, it's a top secret. ;))
I just stumbled upon this post so i thought i'd check with my mini track. No, the bench clamp will not work with the mini track for a couple reasons.
#1, because the screw in the bottom of the clamp is to large for the the mini track.
#2, i don't think the mini track would hold up under the clamping pressure.
you would need to grind the head of the screw down to fit into the track to test it
I just left woodcraft.. This may or may not help, but I bought an Incra T Track and 2 toggle clamps. I'm going to run 1/4 bolts through the toggle clamps into a nut fitting to attach it to the T Track. $40 worth of stuff and didn't drop a ton on the Kreg table.... Hope this helps some.
Hi Justin
Did you install the Inca T Track into the Kreg Router Table?
I'm trying to attach a featherboard to the Kreg Router Table and I don't have the correct hardware to get the featherboards into the Tracks on the Kreg Router Table?
Did you have this problem too?
Any suggestion?
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service