Mini Trak with Bench Klamp?

[scott.barnes]

I am just wondering if its at all possible to use the Bench Klamps with the mini trak? in that i have two of them and was curious if anyones ever done this?

[Roger Pozzi]

I've been watching this post since 01/08/2011 for my own knowledge.

Apparently there is no answer, or, it's a top secret.  ;))

 

[Mandodad]

I just stumbled upon this post so i thought i'd check with my mini track.  No, the bench clamp will not work with the mini track for a couple reasons.

#1, because the screw in the bottom of the clamp is to large for the the mini track.

#2, i don't think the mini track would hold up under the clamping pressure.

you would need to grind the head of the screw down to fit into the track to test it

[justin waldron]

I just left woodcraft..  This may or may not help, but I bought an Incra T Track and 2 toggle clamps.  I'm going to run 1/4 bolts through the toggle clamps into a nut fitting to attach it to the T Track.  $40 worth of stuff and didn't drop a ton on the Kreg table....  Hope this helps some.

[justin waldron]

Check this photo out..

[Robert Melrose]

The bolts on the kreg clamps don't fit in the mini track. Kreg sells klamp track for the clamps. If you used t-bolts with the same thread it would work but you would have to cut them to length.

[Hillary Devere]

Hi Justin

 

Did you install the Inca T Track into the Kreg Router Table?

I'm trying to attach a featherboard to the Kreg Router Table and I don't have the correct hardware to get the featherboards into the Tracks on the Kreg Router Table?

Did you have this problem too?

Any suggestion?