Mike R's Page

What is the correct setting when using 23/32 plywood?I am using the Foreman for plywood that is 23/32 and not 3/4".I put the fence on the 3/4" mark where the back of the fence lines up with the back of the 3/4" raised mark.I set the drill depth using the block and after setting it, the point of the bit looks 1/32 off the fence.I have not had screws poking through.  However, today I had one on a test piece I was doing.  It might be because I put it in at a bad angle.I want to confirm the right…See More

Hi.  My son and I am building some cabinets to hold some band instruments for the local school (an Eagle Scout project).  We are using 3/4" baltic birch plywood (60" x 60" pieces) and Kreg pocket screws (we have the DB210 foreman).  Here is a link to a drawing for the first of 6 cabinets. https://www.dropbox.com/s/u4cojaa3k92ag30/cabinet 5 - Pub.pdf?dl=0This…See More

Hi.  I just go the Adaptive Cutting System and setting it up.  This is my first track saw.On saw calibration, the Kreg video says it "should" be calibrated.  Mine is not.  Just curious if anyone else got one and if it was calibrated.For calibration, Out of the box, the dial is on -1.  If I move it to 0 and lock in with the bevel locks it is square.  I want to make sure I should get it to zero with the set screws on the bottom, then I adjust the the dial to zero after.is the -1 used when you…See More