Tags:
Hi dave
When you get your screws remember course are for softwood fine is for hard
also check on ebay
Phillip is right you dont want to go thru the wood or youll be drilling in the base of your kreg which would be a real bummer
David,
Phillip is exactly right. All of your settings are correct, using the 1-1/2" markings on the jig and on the drill bit. Your drill bit should not exit the end of the 2x4 when properly setup. It should stop just short of exiting the workpiece. This is important for several reasons, which I won't get into here... just know that you are doing everything right so far!
As for your screws, Amazon sells Kreg screws in bulk packages. As do many Kreg retailers including Rockler, Woodcraft, and many more which you can find through our dealer locator.
david.... check your drill bit . make sure your stop collar is set. deep enough. to buy screws in bulk go to your home centers. i buy all my kreg supplys from menards around 18.00 a box for 1 1/4 " course good luck.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service