Raised panel doors - on Kreg router table

[Greg J Powers]

All three of these cuts (raised panel, finger edge, and tongue/ groove) were made on the Kreg router table, with out a coping sled.

 

[Greg J Powers]

Tried to edit this right after i posted and realized it was in the wrong forum. But I could not get back in to edit it. the system locked me out with in the first 3 minutes. This forum is very frustrating with the limited editing function. Even the 15minute window is very limiting, when it works. In this case there was no 15 minutes editing window.

 

The post should be in the "other Kreg Product" forum. 

[KregRep]

Greg, I made the change for you.  I agree with the 15 minute limit criticism.  It'd be nice if Ning allowed me to change these settings to allow for unlimited post-editing.  BTW, your routing looks great!

[Greg J Powers]

Thanks for your help.

KregRep said:

Greg, I made the change for you.  I agree with the 15 minute limit criticism.  It'd be nice if Ning allowed me to change these settings to allow for unlimited post-editing.  BTW, your routing looks great!