bought a couple of Automaxx clamps the other day these are great, I plan on buying a few more , they really make it easy when clamping your wood.
ContinueAdded by JAY DOBBS on June 20, 2014 at 12:48am — 2 Comments
Kreg Members;
Recently I needed to make some long tapers for a friend who was installing his vanity and once level he needed 2 filler strips one against the wall and one along the floor. Well I pulled out my taper jig the metal one that pivots and has a little aluminum hook on the end it did the job but just barley and not really that safe so I put it away and remembered all the different tapering jigs I had used made or worked with over the years all of which did the job but could of…
ContinueAdded by Jeff Metcalf on June 16, 2014 at 11:04pm — 2 Comments
...of my new K4MS Kreg Jig Master System - but I think I should have waited :-(
I've never used a pocket hole system before, but was sold on the idea after I built an odd-shaped door for my under-stair cupboard, so decided to buy this for my next project(s).
I bought the K4 because it was in stock and available, but I see the…
Added by Peter N on June 16, 2014 at 1:59pm — 3 Comments
2020
2019
2018
2017
2016
2015
2014
2013
2012
2011
2010
2009
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
Hello - I have a couple of workbenches in my 'shop' and am contemplating putting 2 or 3 pull out bins on the bottom shelves of both. I've not worked with drawer slides before and am looking to make it simple(r). Thinking of making 2 sets of pocket…Continue
Tags: hole, pocket, basket, slide, Drawer
Started by E M Hampton in General Woodworking Jan 10.
My clamp to hold boards to my kreg jig no longer works. It won't move from it's spot and when I push the grey button on top, nothing happens. are there replacement parts for this?Continue
Started by Tammy in Beginners' Zone. Last reply by John Browne Jan 3.
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 2 Comments
1st impression when you hold this attachment in your hand: "not much to it", Kreg sure is makin' $$ here.
Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.
Then the real test, hook…
Posted by Grampy Meyer on February 23, 2020 at 11:36am — 2 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service