Kreg Owners' Community

All three of these cuts (raised panel, finger edge, and tongue/ groove) were made on the Kreg router table, with out a coping sled.

 

Views: 854

Reply to This

Replies to This Discussion

Tried to edit this right after i posted and realized it was in the wrong forum. But I could not get back in to edit it. the system locked me out with in the first 3 minutes. This forum is very frustrating with the limited editing function. Even the 15minute window is very limiting, when it works. In this case there was no 15 minutes editing window.

 

The post should be in the "other Kreg Product" forum. 

Greg, I made the change for you.  I agree with the 15 minute limit criticism.  It'd be nice if Ning allowed me to change these settings to allow for unlimited post-editing.  BTW, your routing looks great!
Thanks for your help.

KregRep said:
Greg, I made the change for you.  I agree with the 15 minute limit criticism.  It'd be nice if Ning allowed me to change these settings to allow for unlimited post-editing.  BTW, your routing looks great!

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_