"Glenn - very impressive for sure. Ha - what a tease showing those long extrusions.
I see you have a lot of green in the background. I have a couple of the MPC's and have a track saw. I've been using 1x4 standoffs on top of them for…"
"An additional comment- I too would like to learn where I can buy two of the “T” channel connection pieces to connect my second workcenter (as soon as I can swing it).
Finally, I really feel for our southern neighbors in Aussie land and…"
"I got mine last week. Impressive isn’t a strong enough term! I’m going to submit a side by side of my previous “workcenter” with my story as soon as I let myself take it downstairs to my shop. I love the thought that was put…"
"Bruno .. The German benchdog holes (Festool MFT) are 20mm and spaced 96 mm on center. The Kreg workbench holes are 3/4" holes and spaced 100 mm on center ... so it depends what size bench dogs you want to use. Hope this helps.…"
K3 problem the threaded insert is lose and will not hold setting. The k4 is worn and hard to use. I was think maybe epoxy the insert in place may fix it. I tried wood glue did hold. Anyone else had the same problem? The k4 I have thought about…Continue
I'm thinking about getting the Kreg Miter Gauge instead of building a sled for my table saw. I figure the miter gauge would have more uses and since the stock will ride on the saw table there is no drop off like with some crosscut sleds. And it…Continue
I'm having trouble getting my pocket holes deep enough. I'm using the kreg j4 system and using 3/4" stock 1 1/2" wide. I have set my jig to 3/4" high for the stock and set my drill bit to 3/4" to the tip. I'm pretty new at using this and I thought I…Continue
I really like the Adaptive Cutting System (ACS) and hope to buy it soon. My table saw really scares me as I have a bad knee that likes to buckle on me at inopportune times. I can just picture it happening at the table saw and tossing me into the saw…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.