"Hi, Donald. I bought the R3 a couple of years ago, intending to use it on a large project with a few pocket holes. After I looked at the R3 and the project plans for a while, I returned the R3 to the store and bought the K4 system and a…"
"Honestly, though I don't own an R3 (I own the K4 Master system) I think you can do a LOT of great stuff with your current R3 jig. After all, the basic settings of the jig are the screw depth (which stops the drill just before it breaks through…"
Hi AllJust got myself a new Metabo mitre saw, kitted it out with a new Freud Pro blade as well as "pimped up" my bench with LED lighting so I can find stuff! I have 22 LED daylight tubes in my fittings in the garage so there is more than enough…Continue
I originally bought Ridgid tools for the warranty, well I had to replace batteries. Very easy and got new batteries and chargers. Found out they don't make 24 volt tools any more, so I sent in a hammer drill, impact driver and light for replacement…Continue
I am going to try and new project. Never made cabinets before. Researched and You-tubed like crazy. So many opinions. Mine are going to be:1 each= 30"W x 14"D x 38"H2 each =29"W x 14"D x 38"H1 floor to ceiling cabinet 18"W x 24"D and the height…Continue
Perhaps this question has already been asked somewhere on this forum but I wasnt able to find it after an hour or so of searching. Is there a recommended length of Kreg screw to use when combining a 1x6 into a 4x4 post. I have seen a few conversion…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.