I think I have this figured out but just want to check. If joining a 3/4 piece to a 2x4 should I set everything up for 3/4 BUT use the 2 1/2 screws?
Tags:
Phil , I have a chart from Kreg , that shows 3/4 to 1 1/2 boards is 3/4 jig setting with 2 " screws, hope this helps , try this on some scrap boards first , by drilling the holes in the 3/4 " board and screw into the 2x4 ,s JIM
thanks.. is this chart available somewhere???
watched the video and it made much more sense.. thanks for the help
Phil , it is posted on this main page and on my home page
phil vouers said:
thanks.. is this chart available somewhere???
Thanks.. found it.. fantastic
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service