Just curious as to how many of us have a Fire Extinguisher in our workshop,
I have two fire extinguishers which I keep near the entrance to my workshop, one is a small dry powder for electrical or liquid fires and the other is a large 9 litre water extinguisher. There is also a water tap with long garden hose just outside the workshop. So far I have never had to use them, but its good to know that I have something should a fire start.
Tags:
I think good housekeeping in the workshop is another way to minimize the risk of fire as well as many other hazards, A good dust collector that captures the fine dust and wood-chips is a must in any workshop, primarily so we don't breath in the fine dust particles and also to keep the workshop clean.
Al, great topic---thanks for posting.
I have 2 dry chemical fire extinguishers in my garage/shop---a smaller 3lb size near the side entry door, and 5lb size unit, near the main entry door.
Also, a water hose, fitted with a ''quick-connect'' to a quick opening spigot, just outside the garage door entry.
The hose opposite end is equipped with a ''rapid on-off'' nozzle---that provides quick adjustment from a fan spray pattern to a jet stream pattern--- akin to a fire department hose nozzle.
A smoke alarm, is located above the side entry door.
I keep a 5 gal bucket with lid, near the garage door, that contains a couple old bath size dry towels.
The towels can quickly be saturated with water, from the hose, and the water soaked towel(s) placed/tossed over smaller flames, smoldering material, or the like.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service