Kreg Owners' Community

October 2012 Product Reviews (2)

Kreg RipCut

First off I have to say just how much I LOVE my rip cut!! It was easy to set up, so very easy to use and I love the fact that I don't have to ask my hubby to come out and help me when I need to rip down my sheet goods! The only thing that I can say bad about it is that the guide on the left could be a bit longer so that when you get to the end of your cut you are still staying true to the cut itself.  After a couple dozen cuts I've gotten to where I can keep that plane going, but it's still…

Continue

Added by Tracy Smith on October 30, 2012 at 8:59am — 6 Comments

kreg benchtop router table

Hi all just road tested my kreg router table , i give it 8out of 10.

                                  PRO/s

Its well made with a nice flat table.

The insert plate top notch quality.

The plate levellers are a great idea.

Dust extraction via the fence seems to work well.

Assembly fairly simple good instructions.

                                 CON/s

Table should come with hold down brackets.

No nvr switch had too take off my old…

Continue

Added by michael evans on October 14, 2012 at 10:44am — 7 Comments

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_