First off I have to say just how much I LOVE my rip cut!! It was easy to set up, so very easy to use and I love the fact that I don't have to ask my hubby to come out and help me when I need to rip down my sheet goods! The only thing that I can say bad about it is that the guide on the left could be a bit longer so that when you get to the end of your cut you are still staying true to the cut itself. After a couple dozen cuts I've gotten to where I can keep that plane going, but it's still not without a bit of trouble. Thanks for making Kreg my "go to" tools in my workshop! I own several and will always go with Kreg!!
Comment
I got one after they first came out and it was a great improvement over using my circular saw alone, though I've not used it much since I got my radial arm saw.
can't wait to receive the ripcut i ordered online:)
Got a ripcut a few months ago and have used it three times. I have only one saw so I have to set it up everytime. Problem with that is that I have to be very careful during set up. The screws that hold the saw to the ripcut just barely fit my saw but they work. Ripped a sheet of plywood and it was right on. Now I don't worry about big sheets. My table saw is limited to 24 inch width and it was a "pain" to rip big sheets.
I have had my ripcut now for several months, and just tried it out for the first time, last weekend, i had a spare makita saw , so i dedicated it for the ripcut, i love it , works great, i just slow down at the end of my cuts, so they stay true... 4 stars for this product !!
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community