Kreg Owners' Community

July 2014 Product Reviews (3)

Happy with my new K5 but not with the Multi-Mark.

I'm an amateur/beginner woodworker. and just in the process of acquiring tools.  I've just got the K5 and stated working with it and so far so good. I'd like to see 1/2" size screws and matching size in the sizing jig, for thinner boards. as improvement, but other then that I am very happy with it in contrary to the Multi-Mark Measuring tool. which has nice concept but unfortunately I like many others complain about the tool not being tight when measuring 90 degrees, and it has a few…

Continue

Added by PJ on July 22, 2014 at 4:07pm — 8 Comments

Lousy Bits

I have two screw driver bits.  One I got with my Kreg Jr and the head is too small for the screws. It constantly slips and rounds out the head  The other I got with the K5 and it is warped.  I ended up buying some replacements(not Kreg) at our local hardware store and they work perfect.  Has anybody else had problems with their bits or did I just get unlucky?

Added by Bill A on July 20, 2014 at 2:54am — 5 Comments

European Hinges

I'm new to this community and I'm new to carpentry in general. I'm going to make a few cabinet doors and I'm planning to use the European hinges. My dilemma is there are so many brands and styles that I am clueless as to which one to buy. I realize that the decision is partially based on what the inside of the cabinet looks like so I need to make sure I buy the correct ones. I am mainly interested in the adjustable hinge because apparently you can make it perfect even if you are a tiny…

Continue

Added by Rick Grisoli on July 5, 2014 at 4:18pm — 13 Comments

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_