Hi Friends!
Any brand recommendations for nail gun combo units? Also, oil or oiless compressor?
Thanks!
Nick
PS: Thanks to Kreg Tools my teenaged daughter and I have built two garden benches. Now she's hooked and wants to build more! I love it! -N
Tags:
Good reference Ken, thanks
I would stay away from tool shop air nailers. I made that mistake and bought a cheap kit for 60 from Menards. The pin will leave an indentation in your work piece. I tried turning down the pressure and it did not help. I have since purchased the PC 18 gauge and 23 gauge combo from woodcraft and have been very happy with the results.
I purchased the Menards brand 16 gauge finish nailer and used it to install new strand bamboo floors and trim in my new house and I have very good success. Only complaint is that I had a few nails that double fed and caused the gun to miss fire. I noticed the problem when I used the PC 16 gauge nails. I am not sure if it was the gun or a bad batch of nails.
Good luck.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service