Kreg Owners' Community

I am looking for the picture of a router table with a Dust collection system in the back drop. I believe there is a child in the foreground showing off his dad and his handy work. I would like to ask them a few questions. I found it the one time and lost the location or who made it. Any help in locating the picture or the people who built would much appreciated.

Thanks

 

Views: 260

Reply to This

Replies to This Discussion

Hey Greg, I think you looked at mine. I can answer any questions for you if it was mine you saw.

Yes, Justin your is the one.

After looking at all your pictures I am quite impressed. I too would like to put in a dust collection system along one wall and into the can and then out into the open air outside that is.

I have several questions but the one I wanted to know about first was How does that dust collection system "trash can" perform? I bought one and have yet to set it up. Do you have it attached to a vaccum or a dust collector? In order for you to understand what my questions are I will take some pictures of what I have and what my ideas are.  

Where did you get the plans for the table itself? I would like to modify the plans a bit. Again I will take pictures and post them and share my ideas. I have limited space and would like to just use the top half. mounting it on a I guess it would be a buffet thingy.

Thanks for responding.

justin waldron said:

Hey Greg, I think you looked at mine. I can answer any questions for you if it was mine you saw.

Greg,

    Here is the site I got the plans from, there's a cut list and everything here.  http://www.crestonwood.com/router.htm The trash can lid works very well!!  I use it with a dust collector and I am very impressed on how it catches all of the big chips and the fine dust goes to the collector bag. 

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_