I am looking for the picture of a router table with a Dust collection system in the back drop. I believe there is a child in the foreground showing off his dad and his handy work. I would like to ask them a few questions. I found it the one time and lost the location or who made it. Any help in locating the picture or the people who built would much appreciated.
Thanks
Tags:
Yes, Justin your is the one.
After looking at all your pictures I am quite impressed. I too would like to put in a dust collection system along one wall and into the can and then out into the open air outside that is.
I have several questions but the one I wanted to know about first was How does that dust collection system "trash can" perform? I bought one and have yet to set it up. Do you have it attached to a vaccum or a dust collector? In order for you to understand what my questions are I will take some pictures of what I have and what my ideas are.
Where did you get the plans for the table itself? I would like to modify the plans a bit. Again I will take pictures and post them and share my ideas. I have limited space and would like to just use the top half. mounting it on a I guess it would be a buffet thingy.
Thanks for responding.
justin waldron said:
Hey Greg, I think you looked at mine. I can answer any questions for you if it was mine you saw.
Greg,
Here is the site I got the plans from, there's a cut list and everything here. http://www.crestonwood.com/router.htm The trash can lid works very well!! I use it with a dust collector and I am very impressed on how it catches all of the big chips and the fine dust goes to the collector bag.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service