Kreg Owners' Community

Hi all,

I'm about to assemble a small oak kitchen stand (19W x 24L x 36H) with a top and two shelves. I'm connecting 3/4" aprons to 1 7/8" legs with the aprons set 1/2" from the front. Looks like 2" screws would be a good length. The problem is that I can't find 2" fine thread screws anywhere around here and I need to finish the project. I have 2" course screws and 1 1/2 inch fine thread screws on hand. The 1 1/2 inch might work but I would prefer to get a deeper penetration; So I'm leaning toward the 2" course screws.

Any suggestions on which might be better or should I use neither?

Thanks,

Rich L

Views: 485

Reply to This

Replies to This Discussion

Rich, I have not done this on a project yet....I have some soft maple 4/4 that I can try, but I bet it is not going to hold properly......you can usually get the screws pretty quick when you order them through the big ordering place online that starts with an A. (I don't know what the KJF policy is about advertising so I won't actually name them.)

Rick,

Make some sample test pieces, from scrap wood.

That will give you a clue if it'll work.

Also, use screw lube on the threads.

Ken's advice about testing on some scrap is good.

A couple of thoughts:

The 1-1/2" screws should offer plenty of strength for the joints--should have 3/4" or so of penetration.

If you want to use the 2" coarse, you have the added benefit of more wood around the screw hole, which will help prevent splitting. Again, testing would be a good idea, as would lubricating the screws. Though it would create a bit more work, you could drive a 1-1/2" fine-thread screw partway in to create a pilot hole, then remove the screw and insert the 2" coarse.

KregRep

Thanks for the replys. I didn't realize I had some responses. I guess my email notification isn't set right. I'm heading into the garage/shop now to do some tests. I like the idea of starting with the fine thread shorter screws and then stepping up to the longer ones. If the 1-1/2 fine thread screws work though I'd prefer that.

Thanks again

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Popular Posts & Projects 

Videos

  • Add Videos
  • View All

Forum

Untitled

No Description

Started by Joe in Beginners' Zone 20 hours ago.

First time I really had a need for the ACS miter guide.

I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue

Tags: ACS

Started by Adam in General Woodworking May 6.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2022   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_