Tags:
Dear Tom,
I was curious as to what your material thickness is and what kind of screw you are using. If you could let me know I would be able to better assist you.
I'm assuming that they are fine thread correct?
Tom said:
3/4" maple and 1 1/4" screws
Are you sure your drill/driver is big enough? Is the battery still charging properly?
Tom,
When working with hardwoods like this there are a couple of things you can do to get your screws to drive easier. One is like Glen said in that you can use some soap or beeswax on the threads to lubricate them. Another option is that you can drive your screw about halfway in and then back it out some and then finish driving them in. This will allow for the threads to clean out which will allow it to drive easier. The other thing to check is if your drill has clutch settings. If this is set too low it will not give you the proper torque to drive your screw into place.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service