Tags:
Paul,
First if my conversion chart is correct you are dealing with three oak boards each about 2" thick, 13" wide and 94-1/2" long which will yield a tabletop that is approximately 2" thick, 39" wide by 94-1/2" long; a rather large table top.
Now on to constructing it: Using the 1-1/2" setting on the jig with the corresponding screws for that setting should work, especially since you are gluing the boards. When all is set the glue will be providing the majority of the strength. ( I built a router table frame out of 4 by4 legs and 2 by 4 stretchers. I used pocket holes in the 1-1/2" thick stretchers, using the 3/4" setting and 1-1/4" screws drilling pocket holes on both sides of the stretcher. I also used copious amounts of glue since I was dealing with end grain on the stretchers. The router table has performed flawlessly with out coming apart.)
My only concern is the table top cupping with all the Kreg screws being on the bottom. Typically when clamping a panel together clamps are alternately placed on the top and bottom of the panel to offset the stresses. If you could use some clamps on the top side and use cauls to sandwich the panel while the glue is drying. That should offset the tendency of the panel to cup. Lastly if clamps and cauls are not available you could alternate pocket holes on the top and bottom of the panel and use a contrasting wood plug on the top. I saw a project recently where somebody did that and it looks quite sharp.
Hopefully my suggestions help and/or by converting to inches some other suggestions may follow.
Good luck, Don
Here is a link to the project using contrasting pocket hole plugs.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service