Completed project. Three coats of clear polyurethane with 360 grit hand sanding in between followed by a coat of pastw wax. Awaiting delivery.
Tags:
Projects: Hickory 6 drawer dresser
Favorite of 1 person
Comment
Don -- tried your technique on a pair of drawer faces, homemade jig for the plunge router and a V-bit. Easy trick - consistent result. Thanks for the tip! Wife loves them.
Beautiful work, thanks for sharing
Russ, The decorative cuts on the drawer face were done with a 60 degree V-bit and a bearing in my plunge router. I built a jig of scrap wood that sat over the drawer front and ran the router around the edges. Incidentally I used the Kreg jig to assemble the jig. The flutes were made using my router and a jig purchased from Rockler. The crown blocks were made on the drill press using a rosette cutter purchased from Woodcraft. I cut several rosettes in a blank of wood and then cut them to size. Trying to secure a small block of wood to the drill press while cutting the rosette proved almost impossible and not an area I wanted my hands to be ini.
Thanks for all the kind comments from everyone. I will be making a matching chest of drawers in the future.
Don -- that is really awesome. I love the bare look. Very beautiful. If it isn't too much like a magician revealing secrets, how did you do the decorative cut on the drawer faces? Also, did you do the fluted trim and crown blocks from scratch?
Man that is beautiful!
BEAUTIFUL,BEAUTIFUL,BEAUTIFUL.
DON , very nice design and natural finish , love the look of hickory , well done , thanks for sharing , JIM !!
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community