Comment
That is very well done, looks so good where you have it placed and serves a great importance. very good work creating a nice focal point for the cabinatry
Thanks Ray!
Justin, those cabinets and shelves are really fantastic.
Thanks everyone for the comments! John, I have actually built quite a few kitchens and I just lay them out on paper after talking to the homeowners about their storage needs etc. You have to work around the constants, the fridge, stove, dishwasher, sink etc. After it's decided where they're going it's a clean slate of whatever you'd like to build. As far as the Kreg, I use pocket screws to construct the Faceframes and to attach the faceframes to the carcasses and that's it. Put the pocket holes on the outside of the carcass, they're never seen unless it's on an exposed side and then you can veneer the side or use a decorative panel. Drawers are dovetailed with soft close slides and the doors/drawer fronts are 5 piece using a rail and stile set, with soft close hinges too.
Hey Justin... very nice work. Its all in the details brother. You did a professional job and the design is right there too. Did you lay it on paper or did you use a drawing program like Sketch-Up? What percentage do you figure the Kreg tool played in the whole project? I'm new at the Kreg tool thing. I like it, but I can't seem to give up the air powered tools. Thinking about connecting 130 PSI to the Kreg just to make me feel better. Nice work man!
Love this,it look brilliant.Cherry kitchen cabinets are one of the more poplar designs to get today. These go well with a wide variety of kitchen designs, which make them such a hot commodity.
nice work
Justin beautiful work on your new kitchen. I can also see the attention to details. I know it will be enjoyed. Great work. George
I bet your wife is very happy with the new kitchen, Justin. You did a fine job on it. If I was in that kitchen I would love to cook in that refreshing new space. It really shows the craftsmanship and the hard planning does pay off. You really nailed it. Thanks for sharing the new look.
Very nice.
Attractive looking design.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community