Tags:
I don't think the wood movement is so great that it's an issue. I certainly wouldn't glue a table top down, though.
Hi Dick,
I have consulted two professional woodworkers on this subject. Their opinion is if the finished product will be in an air-conditioned location the amount of movement would most likely not cause any problem, the caveat seems to be the top should be small enough that any movement would be minimal, not recommended for large table tops under any circumstances!
Here are some fastners for table & Desk tops that are easy to install that you might be interested in, you have to drill a small pocket for the rails and screw into the bottom of the top. They work well.
http://www.rockler.com/product.cfm?page=786&filter=table%20hard...
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service