I have the Project Centre also. How did you put in the Rivnuts. Did you put the wider part (ie flange) underneath the table. Did you use a tool or just fit a screw and do it up tight thus pulling the rivet up into the hole in the table.…"
First off tried to mention all this to Kreg via Email and just because I live outside the USA seems that the system does not work as they say phone number invalid, which is not.OK bought a Accu-Cut and set it up no problems there worked OK both…Continue
hi all can anybody help got r3 for Xmas and I have noticed that the gray tabs are different think somebody in assembly was talking the piss day and I have 1 metric side and imperial side so they don’t match up hellllp plzericContinue
I watched the setup videos, searched for information and spent half a day and can not get the clamp to hold.i tightened up the screws underneath in various stages up to fully tightened, makes no difference.I do not get the two clicks and I can slide…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.