I would lie to know how to best hold a piece in place that is mitered at 45 degrees while I insert PH screws. It wants to move one direction or another. Is there a tutorial on non-square joints and…Continue
Started this discussion. Last reply by james wilhelm Mar 15, 2013.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (1 comment)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
ROBERT , I read your post and looked at your picture , not sure of the size on your corner posts ? I would clamp the corner post ( top end down ) to a flat work bench,then but the end and side rails to the post and clamp them to the table and screw them to the post , this should keep them in place !!! Doing this to each post,you should be able to turn it over and install your bolt for the corner brace and slide the brace on and snug up the nut. Then put your face clamp on these joints and drive in screws !!! You should be able to use your face clamp on the bottom frame to hold them and drive screws ! Pony also makes an adjustable angle clamp , It is like the ones you would use to make picture frames , but the one side adjusts to 45 angle and would be helpful!!! I hope this helps you out with your next project !!! This may take a few clamps, but it should work. I beleave you can never have to many clamps , check out my page and if you have any ?, S send them to my page , good luck , JIM !!!