"Hi, I new an sorry if there is an answer of my question anywhere. I´m from Germany and inch etc. is not so common here :) So in the table (pdf guide): left side at 7/8" and base board thickness 3/8". On this line every setting…"
"Thanks Jim. I searched the community for "001 chart" and found the photo and printed it. Looks great. Little blurry but I can read it. The chart is much more useful I think than the screw chart I have seen. The one in the…"
"Been thinking about this a bit more. Also looking at the screw selection/jig setting chart. The chart seems accurate as long as the two pieces of wood being joined are the same thickness. As I stated before I joined a 2x4 to a 1x4. In this case the…"
"This morning I made an edge joint with the 1.5" side of a 2x4 and the 3.5" side of a 1x4. The pocket hole went into the 3.5" side (top side) of the 2x4 (serving as a shelf) and the screw entered the 3.5" side of the 1x4. I set…"