The last couple of times I used my k-4 jig, the pocket hole screws did not grip the wood enough to get a tight fit. It has happened more than once. any help in solving this problem. I am using select pine.
Tags:
Just a few questions and comments: What thickness is the pine? Using coarse or fine thread screws? Are you relying on the torque setting on your drill to stop the fastening? Using glue? Here are some things to keep in mind for soft woods: use coarse screws, make sure the cut is square, and when driving the screw do not rely on the clutch setting. Put the drill on slow speed and "listen for the squeak" of the pine as the screw tightens the joint. Try it on some scrap wood. Hope this helps.
I am using 1 by boards with no glue and I have tried both coarse and fine threads with no clutch. I tried to stop the process before it tightens so I can inch it in but at times it will strip out . Thanks for your quick response.
Russ Bransford said:
Just a few questions and comments: What thickness is the pine? Using coarse or fine thread screws? Are you relying on the torque setting on your drill to stop the fastening? Using glue? Here are some things to keep in mind for soft woods: use coarse screws, make sure the cut is square, and when driving the screw do not rely on the clutch setting. Put the drill on slow speed and "listen for the squeak" of the pine as the screw tightens the joint. Try it on some scrap wood. Hope this helps.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service