Kreg Micro Jig Mini...When?

[Joe]

Does Kreg Have a Micro Jig Mini like the mini for the big brother? I am attaching some arched spreaders  to tapered legs of a table. The spreaders are on the diagonal and are 7/8s of an inch going into 1 1/8 inch tapered legs.Sure wish they mede a little single black jig with a 5/16 drill bit as the blue one is just a tad to big, but  it might work.

[Joe]

Hi Robert,
Test piece seem to work ok. But its just a small piece og ley attached to a reject spreader I had. Got to figure out a way to clamp them too so they dont move when the screws bite. But that shouldnt be too hard.

Still, Id prefer to use a smaller drill bit in piece like this. So hey you guys at Kreg, when are you coming out with a micro mini?

Thanks for the tip Robert

[Joe]

Robert it went real smooth, but it is a good thing I save all my scraps till I am done because I needed the piece I cut the arched spreaders out of to give support so I could clamp the thing. It had the perfect matching curve and one flat side. So save everything till you're done.

[Joe]

I just finished the table. I could not have done it without the greg mini jig.

[D S]

Yes! We need a Kreg Micro Poket Jig Mini.

 

It is needed for working on smaller stock, smaller projects.

[Johnny D. Rich]

Here, here! I totally agree. Come on Kreg, get with the program! Also, fix your spell check on here so it doesn't show "Kreg" as a typo.