Tags:
The grey guides should be on the edge of the wood like this, "To get the right Pocket-Hole depth, you’ll have to adjust the position of the collar on the drill bit. Place your bit inside the Depth Setting Gauge on the Kreg Jig®, with the step of the bit at the marking which matches your workpiece thickness, as shown. Slide the Depth Collar towards the jig base and lock it in place with the included Allen Wrench." I got this off the kreg website, hope it helps you out.
Richard you should also be using 1 1/4" screws for 3/4" material.
Hey Robert are you sure about the 1 1/4" screw.
Robert J Guidry Sr said:Richard you should also be using 1 1/4" screws for 3/4" material.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service