Down_Draft_Ezplan.pdf I was looking at Rockler this morning and noticed they had a free plan for a downdraft table so I wanted to share this with everyone. I have seen people have used pegboard for the top, but I'm thinking that you could use MDF for the top and just drill a series of holes in it? Maybe for a non-marring surface you could put rubber grommets in the holes.
Tags:
MDF ? WATH KIND OF TABLE FOR USE? MDF IS NOT GOOD FOR WATER AND ECC
Quite alright, it's early yet!
Justin, I made one with the peg board on top and I basicly used rocklers plans I added a t track to one side to help hold down pcs while sanding, it does a good job in eleminating alot of the dust you get while sanding, and while sanding something like a cabinet door the suction holds the pc in place
Ray, I'm glad to see it works, I'm dying to build one and also get a drum sander too.
David, glad we get to build one!!
I used some thick peg board (commerical type used in stores) and then laminated a piece of heavy duty counter top laminate to the top. Flipped it over and drilled out all the peg board holes in the laminate. Been using it better than five years and no problems and no damage to the project and or the table from the "still running sander" you set down early, reaching for the cup of early morning coffee. A sanding table is definate a good thing to have for keeping the dust down and out of the lungs.
I recently found a piece of heavy plastic type 3/8 thick peg board that I have set aside for a new top when I get around to it. It is used in display racks of commercial stores.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service