Comment
Kerry . . . Helpful video; however you left out how you deal with what for me was the most difficult step in installing this Klamp; i.e., routing out a location for the plate. I managed after building several templates and purchasing a very expensive router bit with the roller guide located near the chuck as opposed to most trim router bits that have the roller guide at the bottom of the bit. It was arduous, time consuming, and a pain in the back side. Unless you or someone out there in the community has a simple solution to the problems I faced I would not imply that there is no problem in locating several small and large plates in various places on your work surfaces. West Davis - new to the community
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue
Tags: ACS
Started by Adam in General Woodworking May 6.
I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue
Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2022 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community