Robert Jacobi's Page

ROBERT ,  I read your post and looked at your picture , not sure of the size on your corner posts ?  I would clamp the corner post  ( top end down ) to a flat work bench,then but the end and side rails  to the post and clamp them to the table and screw them to the post , this should keep them in place !!! Doing  this to each post,you should be able to turn it over and install your bolt for the corner brace and slide the brace on  and snug up the nut.   Then put your face clamp on these joints and drive in screws !!!  You should be able to use your face clamp on the bottom frame  to hold them and drive screws ! Pony also makes an  adjustable angle clamp , It is like the ones you would use to make picture frames , but the one side adjusts to 45  angle and would be helpful!!! I hope this helps you out with your next project !!!  This may take a few clamps, but it should work.  I beleave you can never have to many clamps , check out my page and if you have any ?, S send them to my page , good luck , JIM !!!