"You could adapt the measurement of the width to 3/4 inch less than finish width. For instance a 42x16 cabinet side would be cut to 42x15 1/4 with the top and bottom cut to 15 inches. That is if you are using a typical 3/4 inch face frame."
"Hello. I would drill pockets into the bottom side and use a combination square to set the depth. I am thinking you might also clamp a 6 inch piece of 3/4 to the sides as a spacer right in the middle. Since the picket holes should be 2 to 3 inches…"
"Hello. A fairly easy way to cut the cleats can be to cut 45 degree meters down the length of a 5 or 6 inch wide board on each side. Cut that board in half. Gently or slightly round over the edge to prevent binding. How far apart to put the cleats…"
This might have been discussed before but I can't find the right answer.I recently upgraded to a Kreg 720 Pro and gave away my old R3. The old kit had a chart in inches & mm for setting the collar depth of the Kreg pocket hole drill.…Continue
Hi everyone,Just got my 720 jig. I noticed that when I put the drill bit into the drill guide, it does not go through. The tip of the drill bit does not extrude from the guide. A photo is attached.I wonder if it is normal, because if the bit does…Continue
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…