Hi,
I'm about to build my first wall cabinet, using 3/4 plywood for the box and 1x2s for the face frame. Everything will be assembled using pocket hole joinery. I've attached a basic image of what the cabinet box will look like.
I'm planning to have the face frame flush with the outside of the top and sides of the cabinet box (overlaps on the inside of the box), and flush with the inside of the bottom of the cabinet box (overlap on the outside of the box). I believe this is common cabinet design, and it matches the cabinets in our house.
I'm trying to determine the best way to assemble the bottom of the cabinet box with a 3/4" offset. If the pocket holes were on the inside, I'd simply set the bottom on another piece of 3/4" stock and then drive the screws into the sides, but the holes will be on the outside of the box. Right now i'm thinking about gluing the bottom in place, using a piece of stock to get the 3/4" spacing, and then flipping it over when the glue is dry and driving the pocket hole screws.
I'm not sure if that's a good method, so I'm wondering if anyone has advice on how to best assemble the bottom of my cabinet box? Thanks for your help!
Tags:
It sounds like you've got a solid plan for your wall cabinet construction! Using pocket hole joinery is a great choice for assembly. Your approach to handling the 3/4" offset for the bottom by gluing and then flipping it over sounds like a clever solution. Just make sure to double-check your measurements and alignment before securing everything in place. This design with the face frame flush on different sides of the cabinet box should give it a neat and professional look. https://aqglass.com/ Best of luck with your project! If you have any concerns, don't hesitate to ask for advice. Happy crafting!
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service