When joining 2x4's at a 90* angle, how does the strength of a pocket hole joint (end grain of one board connecting to face grain of another board) compare to that of a mitered joint (both boards cut…Continue
Started this discussion. Last reply by Joe Oct 3, 2015.
I'm going to join 2x4's, such that the pocket holes will go into the 3.5" side of one piece and this will be attached to the 1.5" side of the other piece. I know that if the 3.5" side was going into…Continue
Started this discussion. Last reply by Elizabeth Leveques Dec 30, 2015.
Any recommendations for a circular saw that would make cuts sufficiently square for good pocket hole joints? Preferably a saw with a dust chute/shop vac attachment. I was looking at the …Continue
Started this discussion. Last reply by Elizabeth Leveques Dec 30, 2015.
I was reading online about pocket hole joinery before finding this forum, and ran across this article and…Continue
Started this discussion. Last reply by Richard L. McGlasson Jun 23, 2016.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (3 comments)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
Hello, I am Barrister Anderson Sokki, i like your good profile i saw in this(http://kregjig.ning.com),i will like to be your friend , I also have something very important i want to discuss with you through my private email address (andersonsokki45@gmail.com) please contact me for more
details.Regard Barrister Sokki Anderson
HI JOE , how are you making out with your HF Jig , hope it is working for you , JIM !!
HI Joe , welcome to the community , I noticed on your profile that you do not have a KREG Jig, the K4 or K5 are both good depends on what you want to build !! I have the K4 master set and it work,s good for me , as I have drilled many pocket holes in the last few years and have never drill a pilot hoe in either board !! Make sure when you get your jig you also get a face clamp and a 90 degree clamp and you should not have any problem,s , clamping is very important to get a good tight joint , I also have a good selection of bar and pipe clamps that will help !! Have a good day and happy wood working , JIM !!