I like this portable base a lot, but it has one design flow that I found a little annoying. The 3 mounting holes on the base are not counter sunk to allow mounting screws to be flush with the bottom of the base. Thus when using a jig in the base the jig adjustment are off by the height of the screw head that was used. The jig will not sit flush to the bottom of the base.
Added by Joseph Fehrenbacher on September 20, 2015 at 10:08am — No Comments
Since I bought the Rip Cut I have questioned the quality and design of the tool. It took me multiple times to get it calibrated. I then made one rip cut on 3/4" plywood with my 6 1/2" saw. It did not stay square and totally screwed up my wood. Never going to use that again. It should be all aluminum and they need a better way to mount the saw to the sled. No more screws and more secure.
Added by Duane Dickinson on September 13, 2015 at 5:30pm — 9 Comments
I do love this product, making it easy to build projects for my home. Just started building a book case and hit a snag.
I am using 1/2" material and followed the screw size chart which says the 1" screw and it was too long and came out the other side! I was abruptly disappointed as on my last project I used 3/4" material and it was a breeze.
Anyone had this issue with 1/2" material?
Added by Gw on September 1, 2015 at 5:30am — 3 Comments
2020
2019
2018
2017
2016
2015
2014
2013
2012
2011
2010
2009
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
Hello - I have a couple of workbenches in my 'shop' and am contemplating putting 2 or 3 pull out bins on the bottom shelves of both. I've not worked with drawer slides before and am looking to make it simple(r). Thinking of making 2 sets of pocket…Continue
Tags: hole, pocket, basket, slide, Drawer
Started by E M Hampton in General Woodworking Jan 10.
My clamp to hold boards to my kreg jig no longer works. It won't move from it's spot and when I push the grey button on top, nothing happens. are there replacement parts for this?Continue
Started by Tammy in Beginners' Zone. Last reply by John Browne Jan 3.
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 2 Comments
1st impression when you hold this attachment in your hand: "not much to it", Kreg sure is makin' $$ here.
Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.
Then the real test, hook…
Posted by Grampy Meyer on February 23, 2020 at 11:36am — 2 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service