Kreg Owners' Community

August 2014 Product Reviews (2)

Improvement Suggestion for the Kreg Right-Angle Clamp

Hi there.

I've bout the Kreg Right-Angle Clamp about two months ago and thought to give my two cents take of it for a change. I strongly suggest to make the pin side of the clamp a bit thinner. My problem is that with the standard drill bit that come with the Kreg 5 Jig it is a bit too think and Especially with soft wood (but not only) it tend to rip the hole, now I've just ordered the Mini jig attachment and absolutely sure it will basically be…

Continue

Added by PJ on August 31, 2014 at 5:30pm — 7 Comments

Kreg Jig Mini

English below

..........................................................................................................



Como principiante, uno trata de comprar herramienta y/o accesorios para tu taller o simplemente para reparar algún mueble en casa; estos días he comprado el Kreg Jig Mini.



Debo decir que pensaba que era muy dificil, en fin...un montón de pretextos pero, cuando lo usé por primer vez me quedé impresionado por la rápidez y eficiencia del…

Continue

Added by José Ochoa on August 17, 2014 at 2:30pm — No Comments

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Drawer Slide Jig - How to fit bottom drawer?

Hi guys.I'm probably being really stupid here, but I cant see any way to use the drawer slide jig to fit the bottom drawer of a set?I actually have a couple of questions:Firstly, should the drawer slide fit flush with the bottom of the drawer?(That…Continue

Started by Craig in Beginners' Zone on Sunday.

Combination Pocket Hole and Tongue & Groove Joint

All material is 3/4"Tongue & groove is 1/4" tongue into a 1/4" grooveMy thinking is to set the jig and bit as though I was using 1" stock.  Use the screw called out for 3/4" material.  Is my thinking correct.ThanksGeorgeContinue

Started by George in Beginners' Zone Jun 13.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_