Kreg Owners' Community

June 2010 Product Reviews (2)

KREG Square Cut Tool

As soon as I got back to the shop with the tool, I inverted my 71/4 circle saw and adjusted the tool. I set the guide arm so that it was just inside the teeth on the blade. My blade has staggered teeth. Then I drew my cut line. I then set the guide arm just inside the mark, bingo! Just what I wanted. There is one other thing that I did. The stock was firmly clamped. There is 10 rubber feet on the tool. I set the tool in place, fired up one of my KREG clamps, and, firmly but…

Continue

Added by Buck R. Fleshner on June 20, 2010 at 1:02am — 12 Comments

childrens table and chairs

where can i find plans for and childs table and chairs?

Added by Kevin J. Kelly on June 10, 2010 at 5:38pm — No Comments

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Drawer Slide Jig - How to fit bottom drawer?

Hi guys.I'm probably being really stupid here, but I cant see any way to use the drawer slide jig to fit the bottom drawer of a set?I actually have a couple of questions:Firstly, should the drawer slide fit flush with the bottom of the drawer?(That…Continue

Started by Craig in Beginners' Zone on Sunday.

Combination Pocket Hole and Tongue & Groove Joint

All material is 3/4"Tongue & groove is 1/4" tongue into a 1/4" grooveMy thinking is to set the jig and bit as though I was using 1" stock.  Use the screw called out for 3/4" material.  Is my thinking correct.ThanksGeorgeContinue

Started by George in Beginners' Zone Jun 13.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_