Kreg Owners' Community

May 2014 Product Reviews (3)

stainable wood filler

Always have had a problem finding a filler that will take stain (for pocket holes, for example).  I used a product for the first time today- Elmer's Carpenter's Wood Filler Max- and stained over it.  Best that I have found.  I had to touch up a little over the pocket holes but on the finished product you couldn't see the filler unless you were really looking for it.  Comes in a square plastic tub.  Tom M. 

Added by Tom Mahaffey on May 29, 2014 at 3:19pm — 4 Comments

K5 Kreg Jig

I'm a long time Kreg Jig owner and have always upgraded when new models come to market I attended a seminar with the Kreg Rep for Canada recently and seen the K5 it was not long afterward that I purchased the K5 I'm very impressed with the features and performance of this new product it has all the features that I or anyone would want. I really do not know how Kreg will ever improve on this model. I highly recommend to anyone who is buying or thinking of upgrading to buy the…

Continue

Added by Jeff Metcalf on May 5, 2014 at 9:07pm — 20 Comments

K4

I have used the Kreg R3 Jr. Pocket Hole Jig for a few years and Have been very satisfied with the joints it produced. In addition I have purchased several other Kreg products and have always found them to have superior quality.



Yesterday my new K4 jig arrived from Amazon. While unpacking the jig I noticed the first problem, the weld on the top of the clamp only secured about 1/2 of the length of the joint. From that point I carefully checked the remaining parts.…

Continue

Added by E. John on May 2, 2014 at 1:36pm — 2 Comments

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_