Flip Top Tool Bench

Comment

Comment by Jack Headley on November 23, 2015 at 12:54am

Thanks Jerry

Comment by JERRY VERSICHELLI on November 22, 2015 at 2:01pm

great idea. saving space is important,  to me, also.

Comment by KregRep on November 19, 2015 at 12:18pm

Ashley, and anyone else who is interested in the plans for Jack's Flip-Top Bench, you can find them here.

Comment by Jack Headley on November 19, 2015 at 11:41am

Ashley, if you go over to Kreg's site at buildsomething.com my flip top bench is under the featured plans page and you can get my hand drawn plans there. Thanks

Comment by R. Ashley Burrow on November 19, 2015 at 6:05am

Hey Jack,

 I love your design and it looks very solid I see where you have said you might be willing to share you drawings for the bench you built.I have been looking for plans to build a flip top bench is there a chance you might share them with me?

Thanks Ashley 

Comment by Jack Headley on October 4, 2015 at 2:26pm

Yes Todd I have them standing up, as to not roll around, in the drawer along with the collar rings.

Comment by Todd Fiebranz on October 4, 2015 at 1:36pm

Do you just store all the Sander inserts in the drawer when you have the Sander upside down? 

Comment by Jack Headley on September 26, 2015 at 11:07pm

Those black things are actually just plastic bench dogs that came with benches I picked up at Woodcraft. If you are interested in the drawings I did, give me an email address and I can send them to you

Comment by james wilhelm on September 26, 2015 at 10:35pm

HI JACK, Think I under stand what you did , the shelf that the tools are laged to is 1 1/2 " thick, as the the sides and you run the rod in the middle of the shelf !!  I was looking at the two black things under the shelf  in the pic. with the drill press on top,!!  Think they are the two rods that you put in the sides  on each end  to hold the shelf after you rotate it , is this right , thanks , JIM !!

Comment by Jack Headley on September 26, 2015 at 10:08pm

Hi James, the sides are also two pieces of sande plywood glued and Brad nailed, I just drilled a 1/2" hole through the first piece on both sides. With the rod inserted 3/4" on each side it more than enough support with the solid steel rod.

• ‹ Previous
• 1
• 2
• Next ›
• Page