4 tier shelving unit

4 tier shelving unit for my workshop. I finished it yesterday and am pleased with the outcome. I used my newly purchased Kreg K5 pocket hole jig. I had some problems on the shelving unit. My Kreg screws pocked through the wood on a few of the joints. I double checked the plans I used and I followed the directions. Not sure what I am doing wrong. Any suggestions would be greatly appreciated. I look forward to hearing from you.

View Slideshow
Get Embed Code

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Glen S on September 29, 2018 at 1:01pm: If you double checked your stop collar setting I would venture to guess it is a case of overdriven screws. Pine will cause that because of the knots. Your preset is too high where there aren't any knots or tight grain around them & too low for the areas where the knots & tight grain are present. Just have to watch the joint close as you screw it together. I've even went back & double checked with a hand driver.

You're gonna enjoy all that extra off the floor shelving!! Looks nice!!

RSS

Welcome to
Kreg Owners' Community

Sign Up
or Sign In

Or sign in with:

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.

Videos

Miter Saw Workbench

Added by Mike Criss

The Ottoman with Secret

Added by Alex DrMaster

How to Build a Shaker Fireplace Surround - Woodworking

Added by Philip Miller

Forum

Free Hand Guard (dust collection)

Hi. I'm wondering if anyone has used the Woodpecker Free Hand Guard for dust collection on their bench top router table during pattern routing. How effective is it? It's adaptable to any router table. Continue

Started by Keith Morgan in Beginners' Zone Nov 8.