materials used: 2x6 and 2x4 boards, full sheet of 3/4" MDF, kreg pocket hole screws and brad nails.
tools: miter saw, Kreg pocket hole jig, Ryobi 18v drill and Ryobi brad nailer. There was some trial and error with this but eventually I successfully…
"If you double checked your stop collar setting I would venture to guess it is a case of overdriven screws. Pine will cause that because of the knots. Your preset is too high where there aren't any knots or tight grain around them & too low…"
"thanks for the reply. I am probably over driving the screws. I think I may need some practice on scrap wood to get the technique down. I will also take a look at the charts with screw choices and material. "
4 tier shelving unit for my workshop. I finished it yesterday and am pleased with the outcome. I used my newly purchased Kreg K5 pocket hole jig. I had some problems on the shelving unit. My Kreg screws pocked through the wood on a few of the…
materials used: 2x6 and 2x4 boards, full sheet of 3/4" MDF, kreg pocket hole screws and brad nails.tools: miter saw, Kreg pocket hole jig, Ryobi 18v drill and Ryobi brad nailer. There was some trial and error with this but eventually I successfully…
"Hello, my name is Sandy and I live in NH. I am new to woodworking. The first project I built was a mobile workbench. There was definitely some trial and error but I finished and wanted to try more. My second project is a 4 tier shelving unit for my…"
K3 problem the threaded insert is lose and will not hold setting. The k4 is worn and hard to use. I was think maybe epoxy the insert in place may fix it. I tried wood glue did hold. Anyone else had the same problem? The k4 I have thought about…Continue
I'm thinking about getting the Kreg Miter Gauge instead of building a sled for my table saw. I figure the miter gauge would have more uses and since the stock will ride on the saw table there is no drop off like with some crosscut sleds. And it…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.