Use of Biscuits AND Pocket Hole Screws on Same Joint

[Ken Kortch]

Does anyone use biscuits in addition to pocket hole screws on the very same joint?

I can see where using biscuits - if cut correctly - could really help alignment for both 90-degree joints and edge-to-edge joints. 

I'm not thinking so much for added strength - though I'm sure they can't hurt any. I'm really thinking about keeping the wood from sliding out of position while screwing in the pocket screws.

[Tom Hendrie]

I do use biscuit and Kreg combinations, for example when gluing up a tabletop I put a screw between biscuits to "clamp" the glued joint. This saves on clamps and makes the piece less unwieldy while the glue goes off. It also helps with alignment.