Kreg Owners' Community

Has anyone built or heard of anyone building an L shaped standing desk but with one end of it setup for reloading ammo? 

I have seen pictures from internet searches but the all look like work benches. Was thinking more along the line of a decent looking desk/piece of furniture. 

Any ideas?

Views: 1127

Reply to This

Replies to This Discussion

Everything I build starts with a pencil & erasers. Measure the space you want to put it. Rough out what you think you want,, design wise,, with dimensions. Draw storage for reloading supplies & include if you like open shelving or doors. Maybe some drawers underneath. It doesn't have to be draftsman perfect. Just so you can get a "view" of it. Draw a side view as well.

These drawings should include pocket screws, rabbits,dados,etc.

Have fun & be creative.

I personally loved L-shaped desks they have a larger amount of leg space for stretching out or those with longer legs. The L-Shaped desk can be used in various ways, its widens up your creativity you can place the desk like a V in the room Or you can set the desk perpendicular to the wall or create a U-shaped work area or you can be used this as one of the best stand up desk.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Concealed Hinge Jig Setting Confusion

The Kreg Concealed Hinge Jig has a setting for the distance from edge of the door to the nearest edge of the 35 mm cup hole. This can be set as 3, 4, 5, or 6 mm.Later in the instruction there is a table that converts the distance from the edge of…Continue

Started by Ken Kortch in Kreg Jig® Operation Oct 11.

Help with old Rip-Cut(tm)

I have an old Rip-Cut which I bought many years ago but did not set.  I seem to have lost the instructions, if I ever had them.I cannot figure out which bolts are match with the nylon-lock screws.This unit is old enough that the current instructions…Continue

Started by Sean in Other Kreg® Products Oct 4.

Product Reviews

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 1 Comment

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_