I am making very nice exotic wood cutting boards in anticipation for the coming holidays and I am in need of the proper bit, whether for a router or a wood shaper to create concave rounded forms.
I remember having some bits, the same kind people use for making and shaping doors but I'm unsure as to whether this would work and, if so, which tool would be the most appropriate.
Additionally, where could I get the shaping bits at a decent price.
I will thank in advance the advice any of you would could provide.
Thank you
Tags:
Alfredo,
I met a wood worker who turned into a wood carver---made carvings with chisels and mallots.
He had one good hand, which he used to hold the chisels,
and his ailing hand to swing the mallot.
He noted that it resulted in better control, when performing the finer chiseling/carving tasks---
he couldn't pound hard with the mallots---he only ''tapped'' on the chisel handle,
which is the desired method for chiseling fine detail and lines.
As a result of his ailments, he discovered a new hobby and loves it.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service