Kreg Owners' Community

Hello, I broke a glass table top over the Thanksgiving Holiday. I'm planning to replace it with a oak 3/4" plywood that has a nice look to it.
2 Challenges:
1 - Cut a perfect Circle, I'm thinking I get a way with this with a carefully drawn circle using a center point and a pencil and then cutting it with a jig and then cleaning it up with a router later.
2 - How can I leverage the Kreg jig to finish up the edge with trim? I recall seeing one website that showed one but can't seem to locate it.

Love to get an example.

thanks
-jim

Views: 278

Reply to This

Replies to This Discussion

Ok here"s how I would do it make a router jig with a long enough base so that you can get the radius you need at least 24" for a 48" diameter table use the same jig to cut the out side trim pieces out of flat boards make sure the trim pieces are wide enough to accept a PH
lay out your project full size on a piece of paper to find the miter angles for your trim pieces
Lowes' has a magazine which showed trimming a round table but it was not KPH just curfed plywood and bent it around. I try get article and send it to you if you want
Hi Jim I'm from dracut also if U need a hand I would be glad to help U out. I made a round table out of cherry and I made a circle cutting jig to cut out a 6' round table.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Rip-cut ACS plunge saw

Just got a rip-cut and installed my Bosch saw haven't used it yet but saw was a good fit. Got the original ripcut and didn't really like it had trouble cutting straight. New one has several improvements should make it work much better. especially…Continue

Started by William Burt Brown in General Woodworking Mar 17.

Is the screw driver impact drill rater?

Is the screw driver impact drill rated?Continue

Started by Bob Naylor in Beginners' Zone Mar 10.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_