Kreg Owners' Community

Hello, I broke a glass table top over the Thanksgiving Holiday. I'm planning to replace it with a oak 3/4" plywood that has a nice look to it.
2 Challenges:
1 - Cut a perfect Circle, I'm thinking I get a way with this with a carefully drawn circle using a center point and a pencil and then cutting it with a jig and then cleaning it up with a router later.
2 - How can I leverage the Kreg jig to finish up the edge with trim? I recall seeing one website that showed one but can't seem to locate it.

Love to get an example.

thanks
-jim

Views: 279

Reply to This

Replies to This Discussion

Ok here"s how I would do it make a router jig with a long enough base so that you can get the radius you need at least 24" for a 48" diameter table use the same jig to cut the out side trim pieces out of flat boards make sure the trim pieces are wide enough to accept a PH
lay out your project full size on a piece of paper to find the miter angles for your trim pieces
Lowes' has a magazine which showed trimming a round table but it was not KPH just curfed plywood and bent it around. I try get article and send it to you if you want
Hi Jim I'm from dracut also if U need a hand I would be glad to help U out. I made a round table out of cherry and I made a circle cutting jig to cut out a 6' round table.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Replacing existing slides but cannot remove drawer front

The Kreg slides are made to work with new drawers before putting on the drawer front. In my situation, I cannot remove the existing fronts which means when reversing the jig to hold the draw, it’s at an angle. Not sure what I should do to make them…Continue

Started by Jay Homeyer in General Woodworking Apr 25.

Parts

The Clamp anchor screw broke on my mobile project center.  How can I acquire a replacement?Continue

Started by Jon J Howard in Beginners' Zone Apr 20.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_