Tags:
Rabbet joint is a pretty tough joint to begin with, I don't think you are going to help it out with pocket screws. For one thing, you will just be screwing into the thin part of the back, assuming you were coming in from the side. If you are putting the screw in the back panel, you would be just catching the edge of the side board, likely miss altogether if coming from inside the drawer. The only opportunity to hit any significant amount of wood is coming at it from outside the back panel.
When using a rabbet joint for drawer construction,
I'd suggest fastening the joints with glue and brads/nails.
John,
Thanks for your inputs.
You're always helpful.
I prefer the lock-rabbet joint also.
Like you said , easy to do on a table saw or router table.
Just for schmidts and grins, and a different look, I've inserted 2-3, 1/4" dowels into the front joined section---where the front panel is attached to the side panel.
finished the dowel ends in a dark oak.
John Schaben said:
Pat,
No need for the screws, with the above described joinery.
If you want to give a drawer a different appearance---drill a shallow pocket hole on the visible sides---
insert a plug (dowel), glue in place and cut flush---
stain the plug end with a contrasting color.
Pat Meeuwissen said:
Thanks for the help guys, used glue and brads already and was just hoping there was a special set up which would have allowed for a few screws to be added.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service